Step 1: Turn on the equipment you wish to control.
GE EMSTAR UNIVERSAL CONTROL CODES MANUAL
The Manual Code Search Method (for some older remotes) If it does not, return to step 2 and start the auto search again. If it does, no further programming is required. Step 7: Point the remote at the device and check if the remote operates the device as desired.
Note: You have approximately 2 seconds after the device shuts off or begins playing to lock-in the code. Step 6: When the device shuts off or begins playing, press the #1 button to lock-in the code. Step 5: Place your finger on the #1 button so you are prepared to lock-in the code. Note: the remote must be pointed at your device for the whole duration of this search! The indicator light will flash (approximately every 2 seconds) as the remote searches. Step 4: Point the remote at the device and press and release the "POWER" button (for TV) or "PLAY" button (for DVD, VCR, etc.) to start the search. Repeat this process for each device you wish to control. If not all buttons work as they should, repeat this process to search for a better code. Test the buttons on the remote to see if the device responds as you would expect. The indicator light will flash 2 times after testing the first or last code in each batch of 10. The "VOL–" button can be used to go backwards through each batch of 10 codes. Step 7: When the device turns off, press and release the same device button you pressed in Step 3 to store the code. Be sure to wait approximately 3 seconds after each "VOL+" button press to allow the device time to respond. The remote will resend the last 10 codes one by one. Step 6: With the remote pointed at the device, press and release the "VOL+" button until the device turns off. Step 5: When the device turns off, manually turn the device back on. Repeat this step again and again until your device turns off. The indicator light will blink once for each code and remain on after sending the 10 codes. Wait patiently until the remote sends a batch of 10 codes to the device. Step 4: With the remote pointed at the device, press and release the "POWER" button on the remote once. The indicator light will blink once and then remain on. Step 3: Press and release the desired device button on the remote (TV, DVD, CBL/SAT, etc.). Step 2: Press and hold the "SETUP" button until the indicator light stays on, then release. Step 1: Manually turn on the device you wish to control. If none of the codes listed for your brand work or your brand does not appear in the code lists, instruct your remote to perform a code search. The indicator light will either be a small LED at the top of the remote or the illuminated "ON/OFF" button. If the device turns off/on and responds correctly to common functions like Volume Up/Down or Program Up/Down, no further programming is required. If your equipment does not respond to the first code listed for your brand, repeat the code entry procedure with the next code. Step 5: Aim the remote at the device you want to control and press the "POWER" button. After the code is entered the indicator light will turn off. Step 4: Enter the 3 or 4 digit code using the number buttons. The indicator light will blink then remain lit. For AUX, press AUX button, then the device button you are assigning to AUX. Step 3: Press and release the button for the device you are programming (TV, DVD, VCR, etc.). Step 2: Press and hold the "CODE SEARCH" or "SETUP" button on the remote until the indicator light turns on, then release. Step 1: Turn on the device (TV, DVD, VCR, Satellite receiver etc.) you wish to control. To find out the code(s) compatible with your device, see the GE remote control code lists for 3 digit or 4 digit GE remotes, or search for it here.
GE EMSTAR UNIVERSAL CONTROL CODES HOW TO
GE Universal remote controls - programming instructions How to Program a GE/Jasco Universal Remote Control
0 kommentar(er)
